• Quick Search:

imagenes de la maquina de trituradora de piedra

Comments

PARTIAL REPLACEMENT OF CEMENT BY QUARRY DUST

replacement of cement by quarry dust with percentages 0%, 10%, 20%, 25%, 30%, and end up with 40%. M30 grade of concrete is designed according to IS: 10262:2009 code provisions. Compressive strength of the cubes were casted and cured for 7, 14 & 28 days. From the test data the results were presented in table 3 and also plot is shown in chart1. Fig 1: Compresive Strength Cube CS QD 3.

get price

(PDF) STUDY ON THE REPLACEMENT OF CEMENT AND FINE

Quarry dust is the crusher waste of granite quarries which is about 13-15 % of the total quarry products and accumulation of this waste generates environmental issues. For the past three decades, the scarcity of river sand has been taken seriously

get price

EXPERIMENTAL INVESTIGATION ON PARTIAL REPLACEMENT OF

REPLACEMENT OF CEMENT WITH FLY ASH AND QUARRY DUST AS FINE AGGREGATE T.SAMBA SIVA RAO#1 K. ADITYA NANDINI, M.Tech #2 #1 M.Tech Student, Structural Engineering, MVR College of Engineering, India #2 Assistant Professor, Department of Civil Engineering, MVR College of Engineering, India _____ ABSTRACT----River sand is the most commonly and widely used material

get price

Use of Quarry Dust to Replace Sand in Concrete An

Two grades of concrete M20 and M25 having nominal mix proportion of 1:1.5:3 and 1:1:2 respectively were used by weight and w/c ratio was fixed according to the slump requirement of 60mm. For this concrete mix, quarry dust was added for replacement of sand from 0% to 100% in step of 10%.

get price

(PDF) THE EFFECT OF QUARRY DUST WITH CEMENT BY

quarry dust as the replacement of cement and natural sand sources. Dosage and amount . Malaysian Journal of Civil Engineering 30(3): 415-428 (2017) 419 . of constituents utilize will be record ed

get price

Introduction to Quarry-Dust as Partial Replacement

19/05/2020 The investigation concludes that, as the replacement of the sand with quarry dust increases the workability of the concrete decreases due to the absorption of the water by the quarry dust. The specific gravity is almost same for both the natural river sand and quarry dust. The physical properties parameter like particle size distribution and bulking has shown high variation which can

get price

Can Quarry Dust Replace Sand in a Cement Mix

02/08/2010 Quarry Dust and Cement Mix. Recent research into the potential of quarry dust in cement mixes have focused upon a partial replacement of the sand. The results to far suggest that a cement mix made of quarry dust has an increased workability, making it more flexible and easy to use, but there are doubts about its durability, and compressive

get price

(PDF) EFFECT OF QUARRY DUST AS PARTIAL REPLACEMENT OF

Design mix of M25grade concrete with replacement of 0%, 20%, 25%, 30%, and 35% of quarry dust organized as M1, M2, M3, M4 and M5 respectively have been considered for laboratory analysis viz

get price

Can we make concrete using quarry dust as a replacement

Answer (1 of 7): Yes As quarry dust(also called as crushed sand) is a byproduct obtained after crushing of stones(rocks) to make aggregates. * Results have shown that

get price

Quarry Dust Uses in a Construction Project Concrete Blocks

06/06/2016 Partial replacement of sand with quarry dust will make good concrete that is well desired in residential construction. The final product is strong bricks, slabs or tiles that are produced at lower cost compare to using sand. Saves Cost. Demand for sand from river beds is on the increase, so is getting too expensive daily, a construction project that utilizes quarrydust come at cheaper cost and

get price

Strength Properties of Concrete with Partial Replacement

Results showed that up to 7.5 % replacement of cement by quarry dust there was no reduction in compressive strength, splitting tensile strength and flexural strength. The experimental work was carried out with M sand confirming to zone II as fine aggregate in concrete. Test is also carried out using another fine aggregate, namely bottom ash obtained from the furnace of an

get price

A STUDY ON STRENGTH OF FIBRE REINFORCED CONCRETE WITH

REPLACEMENT OF CEMENT WITH QUARRY DUST AND METAKAOLIN M.Manoj1, B.Sreekala2 M.tech, structural engineering1, Assistant professor2 Nova college of Engineering &Technology, Andhra Pradesh, India1,2 Abstract:--Concrete is the widely used construction material in civil engineering field. The demand and cost of cement is increasing day to day, so

get price

USE OF QUARRY DUST IN CONCRETE AS REPLACEMENT FOR

Use of quarry dust in concrete help in workability of concrete. 6. Quarry dust is a waste product from stone crushing industry and available almost free-of-cost, as partial replacement for river sand. REFERENCES [1] Study of Properties of S using ‘Quarry ust’ and ‘Fly Ash’, M.V. Rama Raju, K.V.Vivek, r.T.Siva Shankar Reddy and P. Srinivas Reddy, Pg.No. 323 to 332,

get price

Partial Replacement of Sand by Quarry Dust in Concrete

investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25). The experimental results showed that the addition of quarry dust as fine aggregate ratio of 30%, 40% and 50% was found to enhance the compressive properties.

get price

(PDF) EFFECT OF QUARRY DUST AS PARTIAL REPLACEMENT OF

Design mix of M25grade concrete with replacement of 0%, 20%, 25%, 30%, and 35% of quarry dust organized as M1, M2, M3, M4 and M5 respectively have

get price

Can Quarry Dust Replace Sand in a Cement Mix

02/08/2010 Quarry Dust and Cement Mix. Recent research into the potential of quarry dust in cement mixes have focused upon a partial replacement of the sand. The results to far suggest that a cement mix made of quarry dust has an increased workability, making it more flexible and easy to use, but there are doubts about its durability, and compressive

get price

EXPERIMENTAL STUDY ON REPLACEMENT OF FINE AGGREGATE

work is an attempt to use Quarry Dust as replacement for Sand. Attempts have been made to study the basic properties of Quarry dust and compressive strength of Quarry dust concrete. The quarry dust behaves similar to conventional fine aggregate (sand) with respect to aggregate properties and zonal study. The optimum compressive strength is achieved at the proportion of

get price

Can we make concrete using quarry dust as a replacement

Answer (1 of 7): Yes As quarry dust(also called as crushed sand) is a byproduct obtained after crushing of stones(rocks) to make aggregates. * Results have shown that

get price

Quarry Dust Uses in a Construction Project Concrete Blocks

06/06/2016 Partial replacement of sand with quarry dust will make good concrete that is well desired in residential construction. The final product is strong bricks, slabs or tiles that are produced at lower cost compare to using sand. Saves Cost. Demand for sand from river beds is on the increase, so is getting too expensive daily, a construction project that utilizes

get price

EXPERIMENTAL STUDY ON STRENGTH CHARACTERISTICS OF CONCRETE

replacement of quarry dust is done. Fly ash aggregates with fly ash-cement proportions of 90:10, 85:15 and 80:20 was manufactured using a 0.3 water-cement ratio in a pelletiser. And test for impact value and crushing value. By this values the best proportion for fly ash aggregate was decided. III. MATERIALS Cement: Ordinary Portland Cement (53 Grade) with specific gravity

get price

Partial Replacement of Quarry Dust and Cement with Ground

bricks in partial replacement of cement and quarry dust with ground-granulated blast- furnace slag following results were found and recorded. 1. In partial replacement of quarry dust with ggbs, the % of water absorption decreases with increase in the % of ggbs. 9.32 11.24 8.17 13.23 0 2 4 6 8 10 12 14 N S1 S2 S3 COMPRESSIVE STRENGTH N/mm 2 SAMPLES 7 DAYS STRENGTH 9.32 10.43 8.13 7.8

get price

Strength Properties of Concrete with Partial Replacement

Results showed that up to 7.5 % replacement of cement by quarry dust there was no reduction in compressive strength, splitting tensile strength and flexural strength. The experimental work was carried out with M sand confirming to zone II as fine aggregate in concrete. Test is also carried out using another fine aggregate, namely bottom ash obtained from the furnace of an industry combined

get price

Can Quarry Dust Replace Sand in a Cement Mix

02/08/2010 Quarry Dust and Cement Mix. Recent research into the potential of quarry dust in cement mixes have focused upon a partial replacement of the sand. The results to far suggest that a cement mix made of quarry dust has an increased workability, making it more flexible and easy to use, but there are doubts about its durability, and compressive

get price

Partial Replacement of Fine Aggregates with Quarry Dust

Partial Replacement of Fine Aggregates with Quarry Dust and Marble Powder in Concrete N. Janakiram [1], P. Murahari Krishna [2] M.Tech student [1], Assistant Professor [2] Department of Civil Engineering PACE Institute of technology India ABSTRACT Quarry dust and Marble powder are the most used among such materials to replace river sand, which can be used as alternative to fine

get price

Studies on Quarry Dust as Partial Replacement of Fine

1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

get price

EXPERIMENTAL STUDY ON REPLACEMENT OF FINE AGGREGATE

work is an attempt to use Quarry Dust as replacement for Sand. Attempts have been made to study the basic properties of Quarry dust and compressive strength of Quarry dust concrete. The quarry dust behaves similar to conventional fine aggregate (sand) with respect to aggregate properties and zonal study. The optimum compressive strength is achieved at the proportion of fine to coarse with 60

get price

Can we make concrete using quarry dust as a replacement

Answer (1 of 7): Yes As quarry dust(also called as crushed sand) is a byproduct obtained after crushing of stones(rocks) to make aggregates. * Results have shown that

get price

EXPERIMENTAL STUDY ON STRENGTH CHARACTERISTICS OF CONCRETE

replacement of quarry dust is done. Fly ash aggregates with fly ash-cement proportions of 90:10, 85:15 and 80:20 was manufactured using a 0.3 water-cement ratio in a pelletiser. And test for impact value and crushing value. By this values the best proportion for fly ash aggregate was decided. III. MATERIALS Cement: Ordinary Portland Cement (53 Grade) with specific gravity of 3.16 was used for

get price

Quarry Dust Uses in a Construction Project Concrete Blocks

06/06/2016 Partial replacement of sand with quarry dust will make good concrete that is well desired in residential construction. The final product is strong bricks, slabs or tiles that are produced at lower cost compare to using sand. Saves Cost. Demand for sand from river beds is on the increase, so is getting too expensive daily, a construction project that utilizes quarrydust come at cheaper cost and

get price

Replacement Of Coarse Aggregate In Concrete [Civil Planets]

Quarry dust For Partial Replacement The bricks, tile & other lightweight materials are made from the quarry dust. The chemical composition of quarry dust is mostly the same as granite rock. So the strength and durability of quarry dust are good to use in concrete.

get price